This page is a wiki. Please login or create an account to begin editing.


3 posts / 0 new
Last post
davorin's picture
Offline
Joined: 2016 Mar 10
G4 quicksilver U-ATA interface

EHLO (o;

Testing a G4 Quicksilver model here.....an attached ID drive to the U-ATA port doesn't show up in the drive setup program...

The drive is okay as I can set it to slave mode and connect to the cable the CD-ROM sits...and install MacOS 9.2.2.

Are there reports of the U-ATA becoming dead on certain Quicksilver models?

Comments

davorin's picture
Offline
Joined: 2016 Mar 10

Stupid me Wink

Just recognized that there was an old Adaptec SCSI card installed...which caused the ATA-2 bus to shut down (o;

the.cook.family's picture
Offline
Joined: 2016 Mar 10

I've done that before.